Filter
Top Products
Raven CDMA User Guide for Verizon, version 2.23 37
Modbus/BSAP Configuration
In the Host Raven’s configuration, instead of IP address for the Addr List (ATM-
LIST or ATMLISTX), substitute a single unique name for each modem, i.e.
remote1, remote2, etc.
When you configure IPManager for the host Raven, make note of your modem
name and domain setting in Wireless ACE in the menu selection Dynamic IP to be
used with the remote modems.
Lors de la configuration de IPManager pour le modèle Raven raccordé à l'hôte,
dans Wireless ACE, relevez le nom du modem ainsi que le nom de domaine corre
-
spondant à l'aide de l'option de menu Dynamic IP.
FIGURE 6. Wireless ACE: Modem Name and Domain
With names instead of IPs for the Address List, the host Raven will query the DNS
server for the current IP assigned to the specific name of a remote Raven to send a
message coroponding to the ID.
Configuring the Remote Ravens for Modbus with
UDP
You can use either Wireless ACE (page 10), direct serial communication or Telnet
(page
53) to configure the modem using AT commands (page 53). This section
covers standard Modbus, variations may need additional commands.
Port
The destination port for the Raven at the host needs to match the device port in use
on all the Ravens at the remote sites. For example, if the remote Raven’s device
port (see below) is "12345", then the Modbus host Raven's S53 destination port
should be set to "12345".