Filter
Top Products
68 Raven CDMA User Guide for Verizon, version 2.23
S51=n n=0 | ASCII
code
PAD data forwarding character.
0 : No forwarding character.
ASCII code of character that will cause data to be for-
warded.
(Used in UDP or TCP PAD mode.)
S82=n n=0 or 2 Enables UDP auto answer (half-open) mode.
0 : Normal mode
2 : Enable UDP auto answer mode.
S83=n n=0-255 Set or query UDP auto answer idle time-out. If no data is
sent or received before the time-out occurs, the current
UDP session will be terminated. While a session is
active, packets from other IPs will be discarded (unless
*UALL is set).
Time-out in seconds.
0 : No idle time-out (Default).
S211=n n=0 | 1 | 3 For applications or situations where hardware control of
the DTR signal is not possible, the modem can be con
-
figured to ignore DTR. When Ignore DTR is enabled,
the modem operates as if the DTR signal is always
asserted.
0 : Use hardware DTR. (default).
1 : Ignore DTR.
3 : Ignore DTR and assert DSR. This value is depre-
cated, and it is recommended to use &S to control the
DSR instead. When this value is set to 3, &S will auto
-
matically be set to 0. See also: &D and &S.
S221=n n = 0 - 255 Connect Delay
Number of seconds to delay the "CONNECT' response
upon establishing a TCP connection.
OR
Number of tenths of seconds to delay before outputting
ENQ on the serial port after the CONNECT when the
ENQ feature is enabled (see *ENQ).
TABLE 6. Local Network and Host Modes
Command Parameters Details