Filter
Top Products
64 Raven CDMA User Guide for Verizon, version 2.23
Cellular Network
The Raven’s cellular network is the connection to CDMA and remote devices or
computers.
TABLE 5. Cellular Network (Verizon’s CDMA)
Command Parameters Details
*NETALLOWZEROIP=n n=0 or 1 Allows the displayed IP address in *NETIP to end in
zero (ex. 192.168.1.0).
0 : Do not allow
1 : Allow
*NETCHAN? none The current active CDMA channel number.
*NETERR? none The EVDO or CDMA network frame error rate.
*NETIP? none The current IP address of the modem reported by the
embedded hardware module (generally obtained from
Carrier). This is the address to which packets can be
sent in order to contact the Raven from the Internet.
Note: If there is no current network IP, 0.0.0.0 may be
displayed.
Refer to *NETALLOWZEROIP if you need to allow
the display of an IP ending in a zero.
*NETOK? none Checks the CDMA connection.
OK if connected.
ERROR if not connected.
*NETRSSI? none The current RSSI (Receive Signal Strength Indicator) of
the Raven as a negative dBm value. The same informa
-
tion is displayed with the command S202?.
*NETSTATE? none See *NETSTATE?.
*NETWDOG=n n=minutes Network connection watchdog: The number of minutes
to wait for a network connection. If no connection is
established within the set number of minutes, the Raven
resets.
Default = 20 min. 0 = Disable.