Filter
Top Products
Raven CDMA User Guide for Verizon, version 2.23 87
Caution: Your account with Verizon may not support message
sending. For most SMS commands (those not preceeded by *),
you will need to have the modem in PassThru mode.
TABLE 18. SMTP (email) and SMS (messaging)
Command Parameters Details
*NETSMS2EMAIL=
[number]
number= SMS/
E-mail server
Specify the SMS/E-mail server number. This is neces-
sary to send an SMS message to an email address
(+CMGS).
*SMTPADDR=
[d.d.d.d][name]Maximum:
40 characters
d.d.d.d=IP
name=
domain name
Specify the IP address or Fully Qualified Domain Name
(FQDN) of the SMTP server to use.
*SMTPFROM=[email]Max-
imum: 30 characters
email= email
address
Sets the email address from which the SMTP message is
being sent.
*SMTPPW=[pass] pass= password Sets the password to use when authenticating the email
account (*SMTPFROM) with the server (*SMT
-
PADDR).
Note: Not required to use SMTP settings but may be
required by carrier.
*SMTPSEND=[email][body
]
email= email
address
body= message
body
Sends an email to the address specified, followed by the
body of the email message.
The email message is terminated and sent by entering a .
or Ctrl-Z on an empty line.
See also *SMTPSUBJ, *SMYPFROM, and *SMT-
PADDR.
*SMTPSTATUS? none Returns the status of the last issued SMTP message
(*SMTPSEND). If no status is available 0 is returned.
Once read, the status is cleared out.
The status codes are received from the SMTP server the
modem attempted to send the request.
Example: 354 = send in progress, 250 = sent ok.
*SMTPSUBJ=[subject] subject= SMTP
message subject
Allows configuration of the default Subject to use if one
isn't specified in the message by providing a "Subject:
xxx" line as the initial message line.