Filter
Top Products
Troubleshooting via the CLI Troubleshooting IP Routing
page 12-8 OmniSwitch Troubleshooting Guide September 2005
The show udp statistics command displays UDP errors and statistics.
-> show udp statistics
Total datagrams received = 349,
Error datagrams received = 0,
No port datagrams received = 28,
Total datagrams sent = 317
Output fields are described below:
The show udp ports command displays the UDP Listener table. The table shows the local IP addresses
and the local port number for each UDP listener.
-> show udp ports
Local Address Local Port
------------------+--------------
0.0.0.0 67
0.0.0.0 161
Output fields are described below:
output definitions
Local Address Local IP address for this TCP connection. If a connection is in the LIS-
TEN state and will accept connections for any IP interface associated
with the node, IP address 0.0.0.0 is used.
Local Port Local port for this TCP connection.
Remote Address Remote IP address for this TCP connection.
Remote Port Remote port number for this TCP connection.
State Describes the state of the TCP connection, as defined in RFC 973. Pos-
sible values are: closed, listen, synSent, synReceived, established,
finWait1, finWait2, closeWait, lastAck, closing, timeWait, and
deleteTCB.
output definitions
Total datagrams received Total number of UDP datagrams delivered to UDP applications.
Error datagrams received Number of UDP datagrams that could not be delivered for any reason.
No port datagrams received Number of UDP datagrams that could not be delivered for reasons
other than lack of application at the destination.
Total datagrams sent Total number of UDP datagrams sent from this switch.
output definitions
Local Address Local IP address for this UDP connection.
Local Port Local port number for this UDP connection.