OmniSwitch Troubleshooting Guide September 2005 page -11
show tech-support layer3 bgp
Creates a log file of the output of several Border Gateway Protocol (BGP) Command Line Interface (CLI)
commands.
show tech-support layer3 bgp
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 7700, 7800, 8800
Usage Guidelines
• This command creates a file called tech_support_bgp.log in the /flash directory of the output
produced by the show ip bgp, show ip bgp statistics, show ip bgp aggregate-address, show ip bgp
network, show ip bgp path, show ip bgp neighbors, show ip bgp neighbors policy, show ip bgp
neighbors statistics, show ip bgp policy community-list, show ip bgp redist-filter, show ip bgp
routes, and show ip bgp debug CLI commands.
• If an existing file called tech_support_bgp.log already exists then it will be overwritten when this
command is executed.
• See the OmniSwitch CLI Reference Guide for more information on show commands.
• See Appendix B, “Debug Commands,” for more information on debug commands.
Examples
-> show tech-support layer3 bgp
............
Release History
Release 5.1; command was introduced.
Related Commands
show tech-support Creates a log file of the output of system-wide CLI commands.
show tech-support layer2 Creates a log file of the output of several Layer 2 CLI commands.
show tech-support layer3 Creates a log file of the output of several Layer 3 CLI commands.