Filter
Top Products
page -6 OmniSwitch Troubleshooting Guide September 2005
show tech-support layer3 pimsm
Creates a log file of the output of several Protocol-Independent Multicast Sparse Mode (PIM-SM)
Command Line Interface (CLI) commands.
show tech-support layer3 pimsm
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 7700, 7800, 8800
Usage Guidelines
• This command creates a file called tech_support_pimsm.log in the /flash directory of the output
produced by the show ip pimsm, show ip pimsm neighbor, show ip pimsm rp-candidate, show ip
pimsm rp-set, show ip pimsm interface, show ip pimsm nexthop, show ip pimsm mroute, and
show ip pimsm debug CLI commands.
• If an existing file called tech_support_pimsm.log already exists then it will be overwritten when this
command is executed.
• See the OmniSwitch CLI Reference Guide for more information on show commands.
• See Appendix B, “Debug Commands,” for more information on debug commands.
Examples
-> show tech-support layer3 pimsm
........
Release History
Release 5.1; command was introduced.
Related Commands
show tech-support Creates a log file of the output of system-wide CLI commands.
show tech-support layer2 Creates a log file of the output of several Layer 2 CLI commands.
show tech-support layer3 Creates a log file of the output of several Layer 3 CLI commands.