Filter
Top Products
page -24 OmniSwitch Troubleshooting Guide September 2005
auth Administratively enables/disables debugging messages for OSPF’s
authentication process.
area Administratively enables/disables debugging messages for OSPF’s area
events.
intf Administratively enables/disables debugging messages for OSPF’s
interface operations.
mip Administratively enables/disables debugging messages for MIP process-
ing of OSPF specific commands.
info Administratively enables/disables debugging messages for purpose to
provide OSPF information.
setup Administratively enables/disables debugging messages for OSPF’s
initialization setup.
time Administratively enables/disables debugging messages for OSPF’s time
related events.
tm Administratively enables/disables debugging messages for DRC’s Task
Manager communication events.
all Administratively enables/disables all debugging listed above for OSPF.
Defaults
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
• The debug command allows you to enable debugging on various OSPF functions. These messages can
be highly detailed, or very general, depending upon the debug level set.
• Use the no form of the command to turn off the selected debugging type.
Examples
-> ip ospf debug-type all
Release History
Release 5.1; command was introduced.
parameter default
error | warning | state | recv |
send | flood | spf | lsdb | rdb |
age | vlink | redist | summary |
dbexch | hello| auth | area | intf
| mip | info | setup | time | tm |
all
error