Filter
Top Products
page -36 OmniSwitch Troubleshooting Guide September 2005
ip rip debug-level
Configures RIP debug level. You can set the level of information displayed using the ip rip debug level
command. The lower the level, the more significant the event. For example, a level of 1 will display only
the most critical problems. A level of 99 would display all of the available information for the specified
debug type. It is best to use the default level of 1 unless instructed to increase the level by a field engineer.
If more information is needed to debug a problem, a higher level can be selected.
ip rip debug-level level
Syntax Definitions
level Debug level. Valid range is 0–255.
Defaults
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
• RIP must be enabled on the switch with the ip rip status CLI command before you can configure the
debug level.
• The debug level applies to all debug types that are configured. You cannot set different levels for each
debug type.
• When the debug level is set to 0, the log is turned off.
Examples
-> ip rip debug-level 3
Release History
Release 5.1; command was introduced.
Related Commands
MIB Objects
alaRipLogTable
alaRipDebugLevel
parameter default
level 1
ip rip debug-type Configures the type of RIP messages to debug.
show ip rip debug Displays the current RIP debug levels and types.