Filter
Top Products
page -34 OmniSwitch Troubleshooting Guide September 2005
ip rip debug-type
Configures the type of RIP messages to debug. The debug feature on the switch is generally used only
under the direction of a field engineer. Use this command to configure the type of RIP debug warnings
(e.g., errors, warning) that will be logged.
ip rip debug-type [error] [warning] [recv] [send] [rdb] [age] [redist] [info] [setup] [time] [tm] [all]
no ip rip debug-type [error] [warning] [recv] [send] [rdb] [age] [redist] [info] [setup] [time] [tm] [all]
Syntax Definitions
error Includes error conditions, failures, processing errors, etc.
warning Includes general warnings, non-fatal conditions.
recv Enables debugging in the receive flow path of the code.
send Enables debugging in the send flow path of the code.
rdb Debugs RIP database handling.
age Debugs code handling database entry aging/timeouts.
redist Debugs redistribution code.
info Provides general information.
setup Provides information during initialization.
time Debugs timeout handler.
all Enables all debug options.
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
• Use the no form of the command to delete a debug type.
• RIP must be enabled on the switch with the ip rip status CLI command before you can configure the
debug type.
• To configure more than one debug type, you must repeat the command for each type.
• Use the debug ip level command to set the debug level for the configured type(s).
Examples
-> ip rip debug-type all