Filter
Top Products
OSPF Troubleshooting Troubleshooting IP Routing
page 12-20 OmniSwitch Troubleshooting Guide September 2005
# of Init State Neighbors = 0,
# of Exchange State Neighbors = 0,
# of Full State Neighbors = 0
This interface has been assigned to area 0.0.0.5. OSPF interface status is down because the administrative
status of the OSPF interface is down. If the priority of the interface is set to 0 then this interface will not
participate in the elections for DR and BDR.
Check to verify that the area 0.0.0.5 was created on the switch and is operational.
-> show ip ospf area 0.0.0.5
Area Id AdminStatus Type OperStatus
---------------+-------------+-------------+------------
0.0.0.0 enabled normal up
0.0.0.5 enabled normal up
Verify that the area-type on both the interfaces is same.
-> show ip ospf area 0.0.0.5
-> show ip ospf area 0.0.0.5
Area Identifier = 0.0.0.5,
Admin Status = Enabled,
Operational Status = Up,
Area Type = normal,
Area Summary = Enabled,
Time since last SPF Run = 00h:00m:00s,
# of Area Border Routers known = 0,
# of AS Border Routers known = 0,
# of Active Virtual Links = 0,
# of LSAs in area = 0,
# of SPF Calculations done = 0,
# of Incremental SPF Calculations done = 0,
# of Neighbors in Init State = 0,
# of Neighbors in Exchange State = 0,
# of Neighbors in Full State = 0,
# of Interfaces attached = 1,
Attached Interfaces =10..40.110.2
Note, that the interface 10.40.110.2 should appear in the area configuration as an attached interface.
Now, check to see if OSPF is enabled globally.
-> show ip ospf
Router Id = 192.168.50.4,
OSPF Version Number = 2,
Admin Status = Enabled,
Area Border Router ? = Yes,
AS Border Router Status = Enabled,
Route Redistribution Status = Disabled,
Route Tag = 0,
SPF Hold Time (in seconds) = 10,
SPF Delay Time (in seconds) = 5,
MTU Checking = Disabled,
# of Routes = 0,
# of AS-External LSAs = 0,
# of self-originated LSAs = 0,
# of LSAs received = 0,