Filter
Top Products
Upgrading an Enterprise 3000 to CMS R3V9
32 CentreVu CMS R3V9 Sun Enterprise 3000 Computer CVUE Instructions
Extracting the customer’s administration and options
To minimize the time that the system is out of service during the upgrade, you can extract
the customer’s administration and options while the system is operating, but do not allow
the customer to make any administration changes while you are performing this procedure.
Note:
When the upgrade is being supported by remote personnel, such as CMS
Provisioning, the system commands in this section are for use by remote
personnel to monitor the progress of the upgrade. Run the commands from
the local console only when instructed to do so, or when there is no remote
support.
To extract the customer’s administration and options:
1. For the tape being used with the upgrade, check for the following:
● Make sure that you are using the correct tape.
● Make sure that the tape is not write-protected.
2. Label the blank tape as “CVUE Extract,” and insert the tape into the tape drive.
!
Important:
If the system has more than one tape drive, the CVUE program defaults to
the tape drive that has a tape installed and that has the lowest SCSI ID. To
help prevent using the wrong tape drive, remove the tapes from any other
tape drives.
3. Document the original position of the key switch. You must return the key switch to this
original position later during the upgrade.
4. If the key switch is in the “Locked” or “Diagnostics” position, move the key switch to the
vertical “On” position. See the following figure.
Sun
U
U
U
U
U
U
U
U
Enterprise
3000
XL
0
12
3
10
11 12
13 14 15
Sun
U
U
U
U
U
U
U
U
There is a bunch of stuff
tha talks about FCC and
other such stuff.
There is a bunch of stuff
tha talks about FCC and
other such stuff.
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
U
key_switch_3000.cdr