Filter
Top Products
Procedures that are done by the customer after the upgrade
Issue 3.0 February 2002 71
R3V8
To copy specific files from an R3V8 system:
1. Insert the most recent CMSADM backup tape from the old system into the tape drive.
2. Enter:
cd /
3. Enter the following command for each file you want to copy:
cpio -icmudv -C 10240 -I /dev/rmt/X -M “Remove current tape,
insert tape number %d, press ENTER” “
<path>/<file_name>
”
The
<path>/<file_name>
is the relative path to the file being copied.
The
X
is either 0 or 1, depending on how many tape drives are connected to the
system. If you have only one tape drive, use 0. If you have more than one tape drive,
use the following commands to determine which tape drive you should use:
mt -f /dev/rmt/0 status
mt -f /dev/rmt/1 status
The tape drive that contains the CMSADM backup tape reports a status similar to the
following:
For example, a command to copy the file /accounting/invoices would be:
cpio -icmudv -C 10240 -I /dev/rmt/X -M “Remove current tape,
insert tape number %d, press ENTER” “accounting/invoices”
<tape drive model name>
:
sense key(0x6)= Unit Attention residual= 0 retries= 0
file no= 0 block no= 0