Filter
Top Products
4. Use D to select the power mode you want. Press E to save the setting.
If you select PSP, you are prompted to enter a PSP algorithm between 1-5.
3 3
X 4
E U D
1 = shortest sleep time (uses battery power quicker, but responds faster); 5 = longest
sleep time (optimal battery conservation, but responds slower).
5. Use U or D to select the PSP algorithm you need. Press E to save the setting. Select
Exit to return to the Configure menu.
Setting the Port
This option sets the port.
1. From the Configure menu, select Port: TCP or LPD.
Protocol
3 TCP
X LPD
E U D
2. Use D to select the protocol you want. For example, if you select LPD, you must specify a
raw printer port:
Port
+ 09100
E U +
Use A as shown in the following table:
E
Press A to
R
Press A to
+
Press A to
Saves the setting
Scrolls through the positions
from left to right
Toggles between + or –; also
increments the current position
setting by 1
3. Press E to save the setting. You return to the Configure menu.
Setting the SSID
This option sets the SSID. The SSID is case-sensitive.
1. From the Configure menu, select SSID.
SSID
ABC 1234
E R +
Use A as shown in the following table:
E
Press A to
R
Press A to
+
Press A to
Saves the setting
Scrolls through the positions
from left to right
Increments the current position
setting by 1 and scrolls through
alpha/special characters
2. When the setting you want is displayed, press E to save the setting. You return to the
Configure menu.
Configuring the 802.11b/g and IP Settings 2-7