Filter
Top Products
Setting the IP Address
This option sets the printer’s IP address.
1. From the Network Configure menu, select IP Address.
2. Press D or U to increase or decrease the highlighted number. Press L or R to highlight a
different number.
3. When you are finished, press R until you see e. Then press e to save the address and
return to the Configure menu. Press X to exit without saving changes.
Setting the Subnet Mask
This option sets the printer’s subnet mask.
1. From the Network Configure menu, select Subnet Mask.
2. Press D or U to increase or decrease the highlighted number. Press L or R to highlight a
different number.
3. When you are finished, press R until you see e. Then press e to save the address and
return to the Configure menu. Press X to exit without saving changes.
Setting the Gateway
This option sets the printer’s router (gateway) address.
1. From the Configure menu, select Gateway.
2. Press D or U to increase or decrease the highlighted number. Press L or R to highlight a
different number.
3. When you are finished, press R until you see e. Press e to save the address and return to
the Configure menu. Press X to exit without saving changes.
Setting the Power Mode
This option sets the power mode to CAM (Continuous Awake Mode) or PSP (Power Save
Protocol). PSP conserves battery power. CAM means the printer is continuously receiving and
transmitting data. This mode uses battery power quickly.
1. From the Configure menu, select Power Mode.
A checkmark indicates the current option.
2. Press U or D until you see the power mode you need. Press e to enable it.
Note: If you select PSP, you are prompted to enter a PSP algorithm between 1-5. 1 - shortest
sleep time (uses battery power quicker, but responds faster); 5 - longest sleep time
(optimal battery conservation, but responds slower).
Configuring the 802.11b/g and IP Settings 2-11