Filter
Top Products
SNMP Netware Traps
You can configure the SNMP Netware traps.
1. From the Alerts and Traps screen, click SNMP Netware Traps.
2. Enter a community name, IPX address, IPX Node address, and the trigger conditions for an
email alert. You can enter up to four IPX addresses.
Note: The S1 port acts as a toggle switch to enable or disable the alerts. You must select S1
to enable the alerts.
3. Click Submit.
4. Click the reset link at the bottom of the screen. The Reset Server screen appears.
5. Click Submit and wait five seconds for the print server to reset.
Even though you submitted your changes, they do not take effect until you reset the print
server.
You must re-enter your access password to make any further changes to the printer
settings.
4-10 System Administrator’s Guide