Filter
Top Products
TELNET CONSOLE COMMANDS
6
Use this chapter to configure the print server using Telnet.
You must have a basic understanding of Telnet commands. For initial setup, do not use Telnet.
Use auto-discover mode. Once you have the IP address, you can use Telnet or a Web browser.
You can use Telnet if you do not have access to the NetManager software.
Note: The default port is Port 23.
To access Telnet console mode:
1. Start Telnet.
2. Press Enter (on your host) until you see the “#” prompt.
3. Type
access as the password and press Enter. (access is the default password.)
4. Press Enter to by-pass the user name. You do not need to enter a username.
Note: The Telnet session times out after 10 minutes of inactivity.
Conventions
This section uses the following conventions:
KEYwords
Type the capitalized letters of each keyword instead of the whole keyword.
Some keywords require more capitalized letters than others. For example,
SEt
KEYVAL
RAdio
[options] Mutually-exclusive options are included within square brackets and
separated by a forward slash. Select only ONE of the options. For
example, [DISable/STRICT/FLEXible]
<values> Values are included within brackets. Values that contain spaces (multiple
words) must be enclosed within quotation marks (""). For example,
SEt NW PW <value>
SEt NW PW "Store 876"
n Numeric digits are indicated by the letter (n). For example,
SEt IP BOot n
SEt IP BOot 5
SEt NW CHannel nn
SEt NW CHannel 11
Settings
1. To view the current wireless settings, type sh nw (show network settings) and press Enter:
WiFi Mode = INFRASTRUCTURE
WiFi SSID: ABC1234
Speed = 54
International Roaming: Flexible
Dynamic Frequency Selection: Unsupported
Regulatory Domain = USI
WiFi FW Ver = 2.13.10.0 LMAC, 2.12.18.0 UMAC
AP density = LOW
Authentication type= OPEN SYSTEM
Encryption is Disabled
Local certificate loaded
AP MAC Address = 00 A0 F8 51 B4 FC
Signal Quality = Excellent (100%)
Connected to SSID ENG4121 on channel 11
Telnet Console Commands 6-1