Filter
Top Products
Troubleshooting
112
113
Q: Why can’t I connect to a paired device?
A: Paired devices are always displayed in My Bluetooth Places even if the remote device is out
of connection range or is turned off. If you can’t connect to a paired device, verify that the remote
member of the pair is within radio range and powered up before you attempt to connect again.
Q: I can’t discover services on an unpaired remote device. What is the problem?
A:
The remote device may not be powered up or may be out of range. To correct this problem, first
verify that the remote device is turned on. If it is, make sure that the remote device is in ‘Connectable’
mode and have provide services which you want. Open the Bluetooth Configuration Panel and select
Accessibility tab. Also perform a Search for Devices to determine if the device is within range.
Q: The Dial-up Networking service does not start. Is this a problem?
A: The Dial-up Networking service will never start unless a properly configured modem is attached
to the server. (Please refer to the Application Setup Guide for details). What you can do:
• Verify that the modem is usable as a local device from the server.
• On the server, in the Bluetooth Configuration Panel, click the Local Services tab, and then
double-click the Dial-up Networking service.
• Click the down arrow in the
Modem field. Select the Startup checkbox and then select the
modem that will be used to dial up.
•
Click OK.
•
Click OK to close the Bluetooth Configuration Panel.