Filter
Top Products
Black Box Console Server user guide 142
CLI commands
add community
user level:
admin
This command enables you to define up to four SNMP communities.
Syntax add community community_name inetaddress
none | readonly | readwrite
Where:
See also
add trap, delete community, set contact, set location, show snmp
add DNS
user level:
admin
This command enables you to define the DNS (Domain Name Service) host or hosts
in your network. You can enter the addresses two DNS hosts in the unit; one will be
referred to as the primary host, the other a secondary host. The DNS hosts do not
have to be the same hosts as entered in your unit’s host table.
On a remote access connection the unit will transmit these addresses to a dial-up
Windows NT/95 client. Therefore, your remote user does not have to configure DNS
parameters in his/her computer.
For more information on DNS see DNS configuration on page 56.
Syntax add DNS internet_address
Note ‘DNS’ must be entered in upper case. Also:
community_name is an arbitrary name assigned to the community.
inetaddress is the internet address that identifies the host(s) in the community.
none | readonly |
readwrite
defines the access permission for the community.
internet address is the internet address of your machine providing the DNS; enter
the address in dot decimal notation.