Filter
Top Products
724-746-5500 | blackbox.com
Page 103
Chapter 7: Command-Line Management
4. Example:
The following example sets the interval WORD (10) when the configuration will be automatically saved to switch:
switch_a(config)#service auto-config interval 10
switch_a(config)#
Firmware Upgrade
1. Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The switch_a# prompt will show on the screen.
switch_a#
2. Usage:
Use install image command to upgrade firmware from tftp server to switch.
3. Command Syntax:
install image IP-ADDRESS WORD
IP-ADDRESS specifies the IP address of tftp server.
WORD specifies the file name to be upgraded to switch.
4. Example:
The following example specifies upgrading firmware (file name: flash.tgz) from the tftp server (IP address: 192.168.1.100) to the
switch:
switch_a#install image 192.168.1.100 flash.tgz
switch_a#
Follow the message on the screen during the firmware upgrade process. Do not turn off the power or perform other
functions during this period of time.
Figure 7-21.
At the “switch_a#” prompt just type in “reload” and press <Enter> to reboot the switch after completing the upgrade process.