Filter
Top Products
724-746-5500 | blackbox.com
Page 176
Chapter 7: Command-Line Management
switch_a(config)#
2. Usage:
Use this command to set the transmit interval. This is the interval between regular transmissions of Link Layer Discovery Protocol
(LLDP) advertisements.
3. Command Syntax:
lldp txinterval <5–32768>
<5–32768> TxInterval 5-32768 seconds, default is 30 seconds.
4. Example:
The following example sets Link Layer Discovery Protocol (LLDP) transmit interval to 60 seconds:
switch_a(config)#lldp txinterval 60
switch_a(config)#
Global TLV Setting:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to configure Link Layer Discovery Protocol (LLDP) Type Length Value (TLV) setting.
Use the no parameter with this command to disable Link Layer Discovery Protocol (LLDP) Type Length Value (TLV) setting.
3. Command Syntax:
(no) lldp tlv-global port-descr | sys-name | sys-descr | sys-cap | mgmt-addrs | port-vlan-id | mac-phy | protocol-identity | vlan-name |
port-and-protocol | power-mdi | link-aggregation | max-frame
port-descr Port Description TLV.
sys-name System Name TLV.
sys-descr System Description TLV.
sys-cap System Capabilities TLV.
mgmt-addrs Management Address TLV.
port-vlan-id Port VLAN ID TLV.
mac-phy MAC/PHY Configuration/Status TLV.
protocol-identity Protocol Identity TLV.
vlan-name VLAN Name TLV.
port-and-protocol Port And Protocol VLAN ID TLV.
power-mdi Power Via MDI TLV.
link-aggregation Link Aggregation TLV.
max-frame Maximum Frame Size TLV.