Filter
Top Products
724-746-5500 | blackbox.com
Page 81
Chapter 6: Web-Based Browser Management
3. GVRP Registration: From the “GVRP Registration” drop-down list, choose “Enable” or “Disable” to enable or disable GVRP
Registration to the port. Configuring an IEEE802.1Q trunk port in registration mode allows dynamic creation (if dynamic VLAN
creation is enabled), registration, and deregistration of VLANs on the trunk port.
4. Update Setting: Click on the “Update Setting” button when you finish Per Port Setting.
Figure 6-72.
IGMP Snooping
IGMP Snooping:
1. Click on “IGMP Snooping” to change to IGMP Snooping windows.
2. IGMP Mode: From the “IGMP Mode” drop-down list, choose “Disable,” “Passive,” or “querier” for the switch.
Disable: Disable IGMP on the switch. Passive: The switch with only multicast-data-forwarding capability.
Querier: The switch acts as the querier for the network. There is only one querier on a network at any time.
3. Update Setting: Click on the “Update Setting” button when you finished IGMP Mode settings.
4. VLAN ID: From the “VLAN ID” drop-down list, choose the VLAN under configuration for the switch.
5. IGMP Version: From the “IGMP Version” drop-down list, choose “1,” “2,” or “3” for the switch.
6. Fast Leave: From the “Fast Leave” drop-down list, choose “Enable” or “Disable” for the switch. Enabling this function will
allow members of a multicast group to leave the group immediately when an IGMP Leave Report Packet is received by the
Switch.
IGMP Querier:
1. Query Interval (1–18000): Click in the “Query Interval” textbox and specify a new number from 1–18000. The Query Interval
field is used to set the time (in seconds) between transmitting IGMP queries. Entries between 1 and 18000 seconds are
allowed. Default = 125.