Filter
Top Products
724-746-5500 | blackbox.com
Page 126
Chapter 7: Command-Line Management
Enable Mode:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use poe enable command to enable this port to discover Powered Device (PD) connected to this port.
Use the no poe enable to disable this function.
3. Command Syntax:
(no) poe enable
4. Example:
The following example shows the use of poe enable to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#poe enable
switch_a(config-if)#
Power Limit by Classification:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use poe power-classification enable command to enable this port to provide power to PD according to classification of maximum
power range used by PD.
Use the no poe power-classification enable to disable this function.
3. Command Syntax:
(no) poe power-classification enable
4. Example:
The following example shows the use of poe power-classification enable to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#poe power-classification enable