Filter
Top Products
724-746-5500 | blackbox.com
Pag e 114
Chapter 7: Command-Line Management
4. Example:
The following example sets high voltage alarm threshold 6 volts for SFP transceiver of interface ge1 (port G1):
switch_a(config)#sfp set-vcc ge1 high-alarm 6
switch_a(config)#
Tx-bias Alarm (Warning) Threshold:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set transmitter laser bias alarm (warning) threshold for SFP transceiver.
3. Command Syntax:
sfp set-tx-bias IFNAME high-alarmhigh-warninglow alarmlow warning LEVEL
IFNAME specifies the name of the interface for which status and configuration information is desired.
LEVEL Threshold value 0 ~ 131 mA.
4. Example:
The following example sets high transmitter laser bias alarm threshold 131 mA for SFP transceiver of interface ge1 (port G1):
switch_a(config)#sfp set-tx-bias ge1 high-alarm 131
switch_a(config)#
Tx-pow Alarm (Warning) Threshold:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set transmitted output power alarm (warning) threshold for SFP transceiver.
3. Command Syntax:
sfp set-tx-pow IFNAME high-alarm | high-warning | low alarm | low warning LEVEL
IFNAME specifies the name of the interface for which status and configuration information is desired.
LEVEL Threshold value -30–8.16 dbm.
4. Example:
The following example sets high transmitted output power alarm threshold 8.16 dbm for SFP transceiver of interface ge1 (port
G1):
switch_a(config)#sfp set-tx-pow ge1 high-alarm 8.16
switch_a(config)#