Filter
Top Products
724-746-5500 | blackbox.com
Page 166
Chapter 7: Command-Line Management
Use the no snmp-server trap-type enable linkUp command to disable link up trap for SNMP.
3. Command Syntax:
(no) snmp-server trap-type enable linkUp
4. Example:
The following example enables link up trap for SNMP:
switch_a(config)#snmp-server trap-type enable linkUp
switch_a(config)#
MAC Notification Trap:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable the Switch to send MAC Notification Trap to the network management system (NMS).
Use the no parameter with this command to disable the Switch to send MAC Notification Trap to the network management
system (NMS).
3. Command Syntax:
snmp-server trap-type enable mac-notification
no snmp-server trap-type enable mac-notification
4. Example:
The following example enables the Switch to send MAC Notification Trap to the network management system (NMS):
switch_a(config)#snmp-server trap-type enable mac-notification
switch_a(config)#
MAC Notification Interval:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to specify the MAC notification trap interval in seconds between each set of traps that are generated.
3. Command Syntax:
snmp-server mac-notification interval <1–65535>
<1–65535> The MAC notification trap interval in seconds.