Filter
Top Products
724-746-5500 | blackbox.com
Page 131
Chapter 7: Command-Line Management
2. Usage:
Use static-channel-group command to create a static aggregator, or add a member port to an already-existing static aggregator.
Use the no static-channel-group command to detach the port from the static aggregator.
3. Command Syntax:
static-channel-group <1-8>
no static-channel-group
<1-8> Channel group number.
Maximum 8 ports in static-channel-group 1 to 6.
Maximum 4 ports in static-channel-group 7 and 8.
4. Example:
The following example adding the interface fe1 (port 1) to static-channel-group 1:
switch_a(config)#interface fe1
switch_a(config-if)#static-channel-group 1
switch_a(config-if)#
Channel Group:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use channel-group command to add a port to a channel group specified by the channel group number (<13>). This command
enables link aggregation on a port, so that it may be selected for aggregation by the local system.
Use the no channel-group command to turn off link aggregation on a port.
3. Command Syntax:
channel-group <1 | 3> mode MODE
no channel-group
<1 | 3> Channel group number.
1 Channel group number 1 for FE ports.
3 Channel group number 3 for GE ports.
Maximum 4 ports in channel-group 1.
Maximum 4 ports in channel-group 3.
MODE
active Enable initiation of LACP negotiation on a port.