Filter
Top Products
724-746-5500 | blackbox.com
Page 179
Chapter 7: Command-Line Management
2. Usage:
Use this command to configure Link Layer Discovery Protocol (LLDP) Type Length Value (TLV) setting on the interface.
Use the no parameter with this command to disable Link Layer Discovery Protocol (LLDP) Type Length Value (TLV) setting on the
interface.
3. Command Syntax:
(no) lldp tlv-global port-descr | sys-name | sys-descr | sys-cap | mgmt-addrs | port-vlan-id | mac-phy | protocol-identity | vlan-name |
port-and-protocol | power-mdi | link-aggregation | max-frame
port-descr Port Description TLV.
sys-name System Name TLV.
sys-descr System Description TLV.
sys-cap System Capabilities TLV.
mgmt-addrs Management Address TLV.
port-vlan-id Port VLAN ID TLV.
mac-phy MAC/PHY Configuration/Status TLV.
protocol-identity Protocol Identity TLV.
vlan-name VLAN Name TLV.
port-and-protocol Port And Protocol VLAN ID TLV.
power-mdi Power Via MDI TLV.
link-aggregation Link Aggregation TLV.
max-frame Maximum Frame Size TLV.
4. Example:
The following example sets Link Layer Discovery Protocol (LLDP) Link Aggregation Type Length Value (TLV) on the interface fe1
(port 1):
switch_a(config)#interface fe1
switch_a(config-if)#lldp tlv-global link-aggregation
switch_a(config-if)#
LLDP Neighbors
1. Command Mode: Exec mode or Privileged Exec mode
Logon to Exec Mode (View Mode) or Privileged Exec Mode (Enable Mode).
The switch_a> or switch_a# prompt will show on the screen.
switch_a>
switch_a#
2. Usage:
Use the show lldp neighbors command to show Link Layer Discovery Protocol (LLDP) neighbors information.