Filter
Top Products
724-746-5500 | blackbox.com
Page 120
Chapter 7: Command-Line Management
2. Usage:
Use port-isolation enable command to enable port isolation.
Use port-isolation disable command to disable port isolation.
3. Command Syntax:
port-isolation (enable | disable)
4. Example:
The following example enables port-isolation to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#port-isolation enable
switch_a(config-if)#
Loopback Detect
LoopBack Detect:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable or disable a loopback detection on a port interface.
3. Command Syntax:
bridge GROUP loopback-detect (enabledisable)
GROUP <1-1> Bridge-group ID used for bridging.
enable Enables a loopback detection on a port interface.
disable Disables a loopback detection on a port interface.
4. Example:
The following example enables a loopback detection for bridge GROUP (1):
switch_a(config)#bridge 1 loopback-detect enable
switch_a(config)#
LoopBack Detect Action:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to configure action while loopback detected.