Filter
Top Products
724-746-5500 | blackbox.com
Page 177
Chapter 7: Command-Line Management
4. Example:
The following example sets Link Layer Discovery Protocol (LLDP) Link Aggregation Type Length Value (TLV):
switch_a(config)#lldp tlv-global link-aggregation
switch_a(config)#
LLDP Ports Settings
Transmit:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to send Link Layer Discovery Protocol (LLDP) packets on the interface.
Use the no parameter with this command to disallow sending Link Layer Discovery Protocol (LLDP) packets on the interface.
3. Command Syntax:
(no) lldp tx-pkt
4. Example:
The following example sends Link Layer Discovery Protocol (LLDP) packets on the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#lldp tx-pkt
switch_a(config-if)#
Receive:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to receive Link Layer Discovery Protocol (LLDP) packets on the interface.
Use the no parameter with this command to disallow receiving Link Layer Discovery Protocol (LLDP) packets on the interface.