Filter
Top Products
724-746-5500 | blackbox.com
Page 129
Chapter 7: Command-Line Management
3. Command Syntax:
poe scheduling enable
4. Example:
The following example enables PoE scheduling to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#poe scheduling enable
switch_a(config-if)#
PoE Schedule:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to set PoE scheduling to this port.
3. Command Syntax:
poe schedule-time DAY HOUR
DAY <0-6> specifies Sunday ~ Saturday to Switch.
HOUR <0-23> specifies hours to Switch.
no poe schedule-time DAY
4. Example:
The following example sets PoE scheduling to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#poe schedule-time 3 0-10,12,14-20, 22-23
switch_a(config-if)#