Filter
Top Products
724-746-5500 | blackbox.com
Page 149
Chapter 7: Command-Line Management
2. Usage:
Use this command to set the Switch priority for running chain protocol. Switch with lower priority will run as Master (forwarding)
port. Use the no form of the command to restore default value (128).
3. Command Syntax:
bridge GROUP chain-priority <0-255>
no bridge GROUP chain-priority
Group = <1-1> Bridge Group name for bridging.
<0-255> The Switch priority for running chain protocol.
4. Example:
The following example sets the new Switch priority (10) to bridge GROUP (1):
switch_a(config)#bridge 1 chain-priority 10
switch_a(config)#
Chain Timeout:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set the Switch timeout count for running chain protocol. Chain recovery time = (Chain Timeout Count – 1) x
200ms.
Use the no form of the command to restore default value (5).
Default Chain recovery time = (5 – 1) x 200ms = 800ms.
3. Command Syntax:
bridge GROUP chain-timeout <3-255>
no bridge GROUP chain-timeout
Group = <1-1> Bridge Group name for bridging.
<3-255> The Switch timeout count for running chain protocol.
4. Example:
The following example sets the new Switch timeout (10) to bridge GROUP (1):
switch_a(config)#bridge 1 chain-timeout 10
switch_a(config)#
Storm Control:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#