724-746-5500 | blackbox.com
Page 127
Chapter 7: Command-Line Management
switch_a(config-if)#
Fixed Power Limit (W):
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to specify the fixed power limit for this port to provide power to PD.
3. Command Syntax:
poe fixed-power-limit LEVEL
LEVEL <1-15.4> specifies the fixed power limit (Watts) for this port to provide power to PD.
4. Example:
The following example sets new fixed power limit 15 Watts to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#poe fixed-power-limit 15
switch_a(config-if)#
Power Priority:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to specify the power priority to this port.
3. Command Syntax:
poe power-priority PRIORITY
PRIORITY specifies high, medium, low power priority for this port.