Filter
Top Products
Print Modes and Options
Print Modes
94
14068L-001 Rev. A X-Plus II User Guide 1/11/07
To set up the printer in Peel-Off mode, complete these steps:
1. Remove the rewind plate (if installed) from the front of the printer. Store it on the two
mounting screws on the inside of the control panel. See Figure 31, Rewind Plate,
on page 119 for more information.
2. Set the printer to Peel-Off mode. See Select Print Mode on page 65 for instructions.
3. Insert media into the printer. See Prepare the Media for Loading on page 32 for
instructions.
4. Open the printhead assembly by rotating the printhead-open lever (1) counter-clockwise.
5. Loosen the thumb screw (not visible from this angle) that is located on the bottom of the
outer media guide (
1).
Caution • While performing any tasks near an open printhead, remove all rings, watches,
hanging necklaces, identification badges, or other metallic objects that could touch the
printhead. You are not required to turn off the printer power when working near an open
printhead, but Brady recommends it as a precaution. If you turn off the power, you will lose
all temporary settings, such as label formats, and you must reload them before you resume
printing.
1
1