Filter
Top Products
181
Specifications
Ribbon Specifications
1/11/07 X-Plus II User Guide 14068L-001 Rev. A
Ribbon Specifications
Refer to the following table for ribbon specifications.
Note • Consider the following when using ribbon:
• Match the ribbon to the label width and printhead width that you are using. The ribbon
should be at least as wide as the labels to protect the printhead from excessive wear.
• Ribbon must be wound with the coated side out.
Ribbon
Specifications
BP-300X-Plus II BP-600X-Plus II BP-360X-Plus II
Printhead resolution 300 dots/inch
(12 dots/mm)
600 dots/inch
(24 dots/mm)
300 dots/inch
(12 dots/mm)
Ribbon width
Minimum
0.79 in. (20 mm) 0.79 in. (20 mm) 2.0 in. (51 mm)
Ribbon width
Maximum
4.33 in. (110 mm) 3.40 in. (87 mm) 6.7 in. (170 mm)
Standard length with
2:1 label to ribbon ratio
984 ft (300 m) 984 ft (300 m) 984 ft (300 m)
Standard length with
3:1 label to ribbon ratio
1476 ft (450 m) 1476 ft (450 m) 1476 ft (450 m)
Ribbon core inside
diameter
1.0 in. (25.4 mm) 1.0 in. (25.4 mm) 1.0 in. (25.4 mm)
Maximum ribbon roll
outside diameter
3.2 in. (81.3 mm) 3.2 in. (81.3 mm) 3.2 in. (81.3 mm)