Filter
Top Products
Configuration
Control Panel Parameters
88
14068L-001 Rev. A X-Plus II User Guide 1/11/07
Adjust LCD Display
This parameter allows you to adjust the brightness of your LCD if it is
difficult to read.
Default: 10
Range: 00 to 19
To change the value shown:
1. Press the right oval to increase the value (increase brightness).
2. Press the left oval to decrease the value (reduce brightness).
Select Format Convert
Selects the bitmap scaling factor. The first number is the original dots per
inch (dpi) value; the second, the dpi to which you would like to scale.
Default: NONE
Selections:
NONE, 150 → 300, 150 → 600, 200 → 600, 300 → 600
To change the value shown:
1. Press the left or right oval to scroll through the options.
Select Idle Display
This parameter selects the LCD options for the real-time clock.
Note • If the default value is not selected, pressing the left or right
oval briefly displays the firmware version of the printer.
Default: FIRMWARE VERSION
Selections: MM/DD/YY (24 HOUR), MM/DD/YY (12 HOUR),
DD/MM/YY (24 HOUR), DD/MM/YY (12 HOUR), FW VERSION
To change the value shown:
1. Press the left or right oval to scroll through the options.
Set Real-Time Clock (RTC) Date
This parameter allows you to set the date following the convention selected
in
IDLE DISPLAY.
To change the value shown:
1. Press the left oval to move to the next digit position.
2. Press the right oval to change the value of the digit.
Set RTC Time
This parameter allows you to set the time following the convention selected
in
IDLE DISPLAY.
To change the value shown:
1. Press the left oval to move to the next digit position.
2. Press the right oval to change the value of the digit.
Table 9 • Printer Parameters (Sheet 25 of 26)
Parameter
Action/Explanation
LCD ADJUST +10
- +
FORMAT CONVERT
- NONE +
IDLE DISPLAY
- FW VERSION +
RTC DATE
- 01/31/01 +
RTC TIME
- 14:55 +