Filter
Top Products
Configuration
Control Panel Parameters
70
14068L-001 Rev. A X-Plus II User Guide 1/11/07
Reset Media Counter for Early Warning
This parameter appears only when Early Warning for Media is enabled.
To reset the media counter:
1. Did you replace the media?
a. If you replaced the media, press the right oval to select YES.
b. If you did not replace the media, press the left oval to select NO.
Set Ribbon Length for Early Warning
This parameter appears only when Early Warning for Media is enabled and
the printer is set for Thermal Transfer operation.
Default: 450 M/1476 FT
Range: 100 M/328 FT to 450 M/1476 FT in 50 M increments
To change the value shown:
1. Press the left or right oval to set the value to match the length of the
ribbon that you are using.
Based on the number entered, when the printer detects that less than
15% of the ribbon remains,
WARNING RIBBON LOW appears on the
LCD. If the alert function is enabled, the printer generates an alert.
When the printhead is opened and then closed after a ribbon warning is
received, the LCD prompts with
RIBBON REPLACED?.
Reset Ribbon Counter for Early Warning
This parameter appears only when Early Warning for Media is enabled and
the printer is set for Thermal Transfer operation.
To reset the ribbon counter:
1. Did you replace the ribbon?
a. If you replaced the ribbon, press the right oval to select YES.
b. If you did not replace the ribbon, press the left oval to select NO.
Table 9 • Printer Parameters (Sheet 7 of 26)
Parameter
Action/Explanation
MEDIA REPLACED?
NO YES
RIBBON LENGTH
- 450M 1476 FT +
RIBBON REPLACED?
NO YES