Filter
Top Products
131
Routine Maintenance
Clean the Snap Plate
1/11/07 X-Plus II User Guide 14068L-001 Rev. A
Clean the Snap Plate
Clean the snap plate when label adhesive or a label is stuck to the underside. Figure 35 shows
the location of the snap plate.
Figure 35 • Snap Plate
To clean the snap plate, complete these steps:
1. See Figure 35. Insert a small-blade screwdriver or similar tool into the loop on the left side
of the snap plate.
2. Gently lift the left side of the snap plate.
3. Insert a small-blade screwdriver or similar tool into the loop on the right side of the snap
plate.
4. Gently lift the right side of the snap plate.
5. Remove the snap plate from the printer.
6. Clean the snap plate with cleaning solvent and a soft cloth.
1
Left loop
2
Snap plate
3
Right loop
1
2
3
Important • Take care not to bend, twist, or otherwise deform the loops. If the snap plate
is damaged in any way, you may need a new plate for proper ribbon sensing.