Filter
Top Products
Configuration
Control Panel Parameters
82
14068L-001 Rev. A X-Plus II User Guide 1/11/07
Select Head Close Option
This parameter sets the action of the media when you close the printhead.
Selections: FEED, CALIBRATION, LENGTH, and NO MOTION
• Feed—feeds the labels to the first registration point.
• Calibration—determines the length of the label and adjusts the
sensor settings.
• Length—In continuous mode, feeds the last stored label length. In
noncontinuous mode, calibrates based on the maximum label length
setting (see Set Maximum Label Length on page 68).
• No Motion—the media does not move. You must press
FEED to
cause the printer to resynch to the start of the next label.
To change the value shown:
1. Press the left or right oval to scroll through the options.
Select Backfeed Sequence
This parameter sets when label backfeed occurs after a label is removed in
some print modes. It has no effect in Rewind mode. This setting is
superseded by
~JS when received as part of a label format (see ZPL II
Programming Guide Volume I).
Default: DEFAULT (90%)
Selections: DEFAULT, AFTER, BEFORE, 10%, 20%, 30%, 40%, 50%,
60%, 70%, 80%, OFF
To change the value shown:
1. Press the left or right oval to scroll through the options.
Adjust Label Top Position
This parameter adjusts the print position vertically on the label. Positive
numbers adjust the label top position farther down the label (away from the
printhead); negative numbers adjust the position up the label (toward the
printhead). The displayed value represents dots.
Default: +000
Range: –120 to +120 dots
To change the value shown:
1. Press the right oval to increase the value.
2. Press the left oval to decrease the value.
Table 9 • Printer Parameters (Sheet 19 of 26)
Parameter
Action/Explanation
HEAD CLOSE
- +
BACKFEED
- DEFAULT +
LABEL TOP +000
- +