Filter
Top Products
4
CHAPTER FOUR
Initial
Setup
29
Getting Started
Setting the Dialling Mode (Tone/Pulse)
Your machine is initially set to TONE. If you are using a PULSE dial
line, you can change the setting to PULSE by following the steps below.
1
For the MFC-9050, Press Menu, 1, 1.
For the MFC-9550, Press Menu, 1, 1, 1.
The screen prompts you to select TONE or PULSE.
DIALLING:TONE
DIALLING:PULSE
2
Use or to select the dialling mode.
3
Press Set when the screen displays the dialling mode you want.
4
Press Stop to exit.
Although this equipment can use either Pulse or Tone signalling, only the
performance of the Tone signalling is subject to regulatory requirements
for correct operation. It is therefore strongly recommended that the
equipment is set to use the Tone signalling for access to public or private
emergency services. The Tone signalling also provides faster call set up.