Filter
Top Products
Message Is Displayed
15
7-15
Feed Limit
Problem 1: You pressed on the operation panel to feed more media than allowed.
Solution: Open the tray, then turn the roll holder manually to feed the extra media.
Size Undetected
Problem 1: The media has shifted out of the correct load position, or the media is
curled.
Solution: Set the media correctly. (Æ P.2-8, P.2-20)
Problem 2: The printer interior is dusty or dirty.
Solution: Open the upper cover and clean inside the printer. (Æ P.6-11)
Remove Ink Tank
Problem 1: Right cover was closed without removing the ink tank.
Solution: Remove the ink tank.
Turn Power Off!!
Problem 1: The tape inside the upper cover or the belt stopper have not been removed.
Solution: Switch the printer off, open the upper cover, remove the tape and belt
stopper, then press the Power button. (Æ Setup Guide)
Problem 2: The printer has malfunctioned.
Solution: Switch the printer off, then press and hold down the Power button for over
3 seconds to switch the printer on again.
Solution: If the message occurs again after switching the printer off and on, note the
message in the first line of the operation panel display, then call for
service.
W-Ink Full Soon
Problem 1: The waste ink tank is nearly full and requires replacing very soon.
Solution: Printing can continue after this message is displayed. However, you should
call for service as soon as possible before a Service Call is issued.