Filter
Top Products
25
metal (w/o a belt) Green Belt Aligner Roller itself. Note that the two metal
surfaces are flush.
Step 12: Remove the Green Belt Aligner Roller Assembly by removing the “4”
screws.
Important: Leave the Coupler attached.
Assembly Process
Step 13: Stretch the new green belt onto the Aligner Roller Assembly, green side
out.
• Take care when handling the Aligner Roller Assembly so as not to
damage the Flex Coupling.
• Rotate the shaft to confirm that the belt tracks properly.
Step 14: Slide the Aligner into place, loosely
attach the “4” Pan Head Screws with
the “4” Lock Washers.
BELT
STRETCH
ROTATE
Check that the metal surface of the Aligner Roller Assembly is flush with the Sheet
Metal surface of the Paper Guide. A 12” metal ruler works well to check this
adjustment. Slip the ruler under the green belt and press it flat against the two
surfaces. Adjust the Aligner and snug
the screws when perfectly flush.
NOTE: The green belt should look like the drawing shown after step 11.