40
6. OPERATING CONTROLS
6.1 PUNCHING PATTERNS
The Professional Puncher-A1 uses a variety of easily interchangeable die sets that
allow you to punch documents in line for several different binding styles. By selecting
the appropriate die set, you can use your Professional Puncher-A1 to punch
documents in any of the binding styles.
North America (Letter) Europe (A4)
3-hole 4-hole / 2hole
Velo Bind 11-hole Velo Bind 12-hole
CombBind 19-hole CombBind 20 or 21
Wire Bind (2 types) square
- 21-hole Wire Bind
- 32-hole Wire Bind
Wire Bind (2 types) Round
- 23-hole Wire Bind
- 34-hole Wire Bind
Color coil 44-hole (2 types)
- 44-hole RND
- 44-hole Oval
Color Coil 47 hole (2 types)
- 47-hole – RND
- 47-hole – Oval
ProClick 32-hole ProClick 34-hole
Please note that each punching style listed above requires a separate die set for the
Professional Puncher-A1. The Professional Puncher-A1 can hold up to four Die
Sets within it’s cabinet (one in the operating slot and three in the storage area.
To purchase additional or separate Die Sets, contact your authorized reseller.
6.2 CHANGING THE PUNCH DIE SETS
Your Professional Puncher-A1 offers the convenience of interchangeable die sets,
allowing you to economically punch documents for a wide variety of binding styles.
Changing the machines die sets is both quick and easy, as the following instructions
illustrate:
Removing Die Sets from the Machine: The interchangeable die set slot of the
Professional Puncher-A1 is located on the right front side of the machine. If a die
set “M” is already installed in your Professional Puncher-A1, you can easily remove
the die set by following these instructions:
Step 1: Stop the printer/copier.
Step 2: Open the Professional Puncher-A1 access door panel.
Step 3: Set Professional Puncher-A1 to the OFF (O) mode.
Step 4: Securely grasp the handle and tug firmly. This firm tug disengages the
Automatic Latching Mechanism, and allows the die set to slide out.
Step 5: Continue pulling on the handle until the Die Set is fully removed.
Step 6: Properly store the removed Die Set in the Die Set storage area of the
Professional Puncher-A1 (keep away from dust, dirt, accidental falls
from the edge of counters etc.).