Filter
Top Products
4
4-9 Profile Manager
3. Select the “Appear in Driver as” checkbox, choose one of the predefined
custom simulation names (Simulation-1 through Simulation-10) from the
pop-up menu, and then click Apply.
Make sure to choose a name that is not already linked with another
simulation. If you try to define two profiles with the same name, you will get
an error message.
For an output profile, the predefined custom names would be Output-1
through Output-10.
NOTE: While you cannot delete a preset profile, you can use a preset profile’s
name for your downloaded profile when you select the “Appear in Driver as”
option. This replaces the preset profile with your own profile.
When you choose Profile Settings for an output profile, the Use Calibration
Set option also appears. You must calibrate the iR C2100/2100S with this
calibration set before this option has any effect. If you have never measured
for this calibration set, default measurements will be used. For more
information about calibration sets, see page 3-2.
In Profile Settings you can also change profile descriptions for all non-locked
profiles.