Filter
Top Products
64 Cisco Unified Web and E-Mail Interaction Manager Installation Guide
Configuring permissions for installation directory
For security reasons, change the permissions for the installation directory. In a distributed installation, carry out
these tasks on the file server.
To configure permissions:
1. Remove permissions to everyone from the
cisco
share.
2. Give full control to the domain user account that you had created earlier for Cisco Interaction Manager
services (page 16).
Configuring a web site for the messaging applet
When the application is accessed, a messaging applet is launched in the browser. This applet gets messages for
the user from the database.
This section explains the procedures that you must perform to configure a new web site for the messaging applet.
These include:
Creating a new web site
Verifying messaging applet web site
Configuring the properties of the new web site
Creating virtual directories
Configuring the Applet host setting
Creating a new web site
You need to create a new web site for the messaging applet. From here on in the document, the new web site is
referred to as Messaging Applet web site.
To configure a new web site:
1. Go to Start > Settings > Control Panel > Administrative Tools > Internet Information Services.
2. Browse to Web Sites.
3. Right-click Web Sites and click New > Web Site.
Important: You need to perform these tasks only if you are using a load balancer in your
installation and your installation includes Unified WIM.
Important: Before you start, get another IP address assigned to the web server. Make sure that
both the IP addresses map to the same LAN card. Also, get a fully qualified domain name for the
new IP address.