Filter
Top Products
1-4
Cisco AS5800 Universal Access Server Dial Shelf Card Guide
78-7097-03 0A
Chapter1 Replacing or Installing Dial Shelf Cards
Removing a Dial Shelf Card
Figure 1-1 Using the Ejector Lever
Step 7
Pull either the top or bottom ejector lever away from the card’s front panel to disengage the trunk card
from the backplane connector. (See Figure 1-2.)
Caution Always use the ejector levers to disengage or seat dial shelf cards in the backplane. Failure
to do so can cause erroneous system error messages indicating a card failure. However, do
not use the ejector levers to lift or support the weight of the cards.
Step 8 Grasp the ejector levers and pull the card partially out of the dial shelf slot until you can grasp the card
front panel with one hand. Place your other hand under the card to balance the weight of the card as you
pull it out of the slot. (See Figure 1-2.)
Step 9 For all cards, read the following warning, then proceed to Step 10.
Warning
High performance devices on this card can get hot during operation, To remove the card,
hold it by the faceplate and bottom edge. Allow the card to cool before touching any
other part of it or placing it in an anti-static bag. To see translations of the warnings that
appear in this publication, refer to the Regulatory Compliance and Safety Information
document that accompanied this device.
Step 10 Pull the card straight out of the slot. Avoid touching the circuitry or any connector pins.
PWR
E1FR
HCPU
MAINT
T1FR
FCPU
RALM
LALM
MONITOR#
NLOOP
75
PWR
E1FR
HCPU
MAINT
T1FR
FCPU
RALM
LALM
0
MONITOR#
NLOOP
75
PWR
HCPU
CALLS
MAINT
MODEMS
H11097
PWR
E1FR
HCPU
MAINT
T1FR
FCPU
PWR
E1FR
HCPU
MAINT
T1FR
FCPU
Panel fastener