Filter
Top Products
2-6
Cisco AS5800 Universal Access Server Dial Shelf Card Guide
78-7097-03 0A
Chapter 2 Channelized T1 or E1 Trunk Card
CT1 and CE1 Trunk Card Overview
To enable the bantam jacks for port monitoring, follow these steps:
Step 1 Push and quickly release the monitor button below the LCD to toggle to the port number you want to
monitor.
You must release the button within 2 seconds to advance through the port numbers (from 0 to 11). After
port 11, the display returns to port 0. As you advance through the port numbers, the LEDs reflect
configuration status and alarm conditions for the port number displayed in the LCD.
Step 2 Push and hold the monitor button for 2 or more seconds to enable the bantam jack. To disable the bantam
jack and return to toggle mode, press the button again and hold it for two or more seconds.
When you release the button, the port LCD no longer toggles through the port numbers, the letter “B” is
displayed in the LCD, and the bantam jacks are enabled.
Step 3 Repeat Step 1 and Step 2 to enable the bantam jacks for each port that you want to monitor.
Figure 2-4 CT1 and CE1 Trunk Card Front Panel LCD and Bantam Jacks
+
–
+
–
1 TxD+
2 TxD–
3 RxD+
6 RxD–
H11006
GRP