Filter
Top Products
5-5
Cisco 2010 Connected Grid Router Hardware Installation Guide
OL-31454-01
Chapter 5 Installing and Upgrading Internal Modules
Removing and Installing Compact Flash Memory Cards
Figure 5-3 Compact Flash Memory Card Slot in Cisco CGR 2010
Step 3
Press the ejector button again (see Figure 5-3). This ejects the compact flash memory card part-way out
of its slot.
Step 4 Pull the compact flash memory card out of its slot.
Step 5 Push the ejector button in until the button is flush with the bezel.
Caution To prevent damage to the ejector mechanism, the ejector button must remain pressed in all the way (flush
against the bezel) when not being used to eject a compact flash memory card.
Installing a Compact Flash Memory Card
To install a compact flash memory card, perform the following steps:
Step 1 Make sure that the ejector button is fully seated until it is flush with the bezel.
Note If the ejector button is projecting out from the panel, push it in until it is flush with the bezel.
Step 2 Insert the compact flash memory card into the slot until it is fully seated. The ejector button remains
flush with the panel.
1 Ejector button 2 Compact flash slot
277600
PSU2
PSU OK
PWR-150W-HV
CF1 CF0
DO NOT REMOVE DURING
NETWORK OPERATION
1
2
DO NOT REMOVE DURING
NETWORK OPERATION
Cisco Connected
PS
Type
Lo V DC
Hi V DC
or
V AC