Filter
Top Products
CHAPTER
4-1
Cisco 2010 Connected Grid Router Hardware Installation Guide
OL-31454-01
4
Configuring the Router
This document describes how to power up the router and perform the initial configuration in the
following sections:
• Powering up the Router
• Performing the Initial Configuration on the Router
• Verifying the Initial Configuration
Powering up the Router
Warning
Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement
1029
This section covers the following topics:
• Powering up the Router, page 4-1
• Performing the Initial Configuration on the Router, page 4-3
• Verifying Network Connectivity, page 4-20
• Verifying the Initial Configuration, page 4-24
Checklist for Power Up
Check the following items before powering up the router:
• Chassis is securely mounted and grounded.
• Interface cables are connected.
• Compact flash memory card is properly seated into its slot. For installation instructions, see the
“Removing and Installing Compact Flash Memory Cards” section on page 5-2.
• PC with terminal emulation program (HyperTerminal or equivalent) is connected to the console port
and configured for 9600 baud, 8 data bits, 1 stop bit, no parity, and flow control is set to “none.”
• Suitable PC COM port is selected in the terminal emulation program.