Filter
Top Products
3-5
Cisco 2010 Connected Grid Router Hardware Installation Guide
OL-31454-01
Chapter 3 Installing and Connecting the Router
Installing the Router in a Rack
Installing the Router in a Rack
The Cisco CGR 2010 router can only be mounted in a rack.
Caution To prevent damage to the chassis, never attempt to lift or tilt the chassis by holding it by the plastic panel
on the front. Always hold the chassis by the sides of the metal body.
Note Allow at least one rack unit of vertical space above the router.
Rack-Mounting the Chassis
The Cisco CGR 2010 router can be installed in a 19-inch (48.26-cm) standard rack.
You can mount the router in the following ways:
• Power-supply side mounting—Brackets attached at the power supply side of the chassis with the
power-supply side facing forward.
• Cable-side mounting—Brackets attached at the cable side of the chassis with the cable side facing
forward.
Figure 3-1 shows the rack-mount brackets used with the Cisco CGR 2010 router.
Figure 3-1 Rack-Mount Brackets for the Cisco CGR 2010 Router
249218