Filter
Top Products
1-6
Cisco 2010 Connected Grid Router Hardware Installation Guide
OL-31454-01
Chapter 1 Overview of the Router
Hardware Features
The SFP port shares the same physical port as an RJ-45 GE port. The SFP port can be configured for the
following behaviors:
• Always use the RJ-45 port.
• Always use the SFP port.
USB Console Port
The Mini-USB type B port has been enabled to perform management tasks on the router. To use this port,
you must install a Windows USB device driver before establishing physical connectivity between a
personal computer and the router. See the “Installing the Cisco Microsoft Windows USB Device Driver”
section on page 3-21 for driver installation instructions.
Removable and Interchangeable Modules and Cards
GRWICs and power supply units (PSU) for the Cisco CGR 2010 fit into external slots and can be
removed or replaced without opening the chassis.
Note See Installing Cisco Interface Cards in Cisco Access Routers document at:
http://www.cisco.com/en/US/docs/routers/access/interfaces/ic/hardware/installation/guide/inst_ic.html
for instructions that describe how to install GRWICs in the router.
Grid Router WAN Interface Cards
GRWICs are the latest generation of interface cards. GRWICs are installed in the GRWIC slots on the
router (see Figure 5-7 on page 5-10).
Commercial SFPs
32 to 113°F (0 to 45°C)
• GLC-BX-U with digital optical monitoring
(DOM) support
• GLC-BX-D with DOM support
• GLC-FE-100LX
• GLC-FE-100BX-D
• GLC-FE-100BX-U
• GLC-FE-100FX
• GLC-FE-100EX
• GLC-FE-100ZX
• CWDM-SFP with DOM support
Extended temperature SFPs
23 to 140°F (-5 to 60°C)
• SFP-GE-S with DOM support
• SFP-GE-L with DOM support
• SFP-GE-Z with DOM support
Table 1-2 Supported SFP Modules (continued)
Type of SFP Module Model